3D printed case! Improved over acrylic

[Sushi]

Printed my very own case for the Gamebuino! The stock case had standoffs in the back which were wearing out because of my constantly opening and closing it. No problem now! It also uses four screws as opposed to the eight otherwise. Plus, it glows in the dark and's much lighter than the acrylic.

The linkasaur

[erico]

Pretty great! Well done.

...reminds me of those bone dinosaurs from a loooong time ago. Can you get a nite picture of it?

[Sushi]

Here you go!
The linksy

[Drakker]

Now you need to make one that wraps around the Gamebuino and that looks like a good old Gameboy Advance and you'll get rich instantly. ;)

[Sushi]

Now you need to make one that wraps around the Gamebuino and that looks like a good old Gameboy Advance and you'll get rich instantly.

I'm actually working on that right now! Your read my mind...

[erico]

Terrifyingly AWESOME!

What about an original design?

[Sushi]

Dunno about original. Will probably base it off if this just so it fits nicely. But sure, it could probably look entirely different.

[ripper121]

Pleas share it on thingiverse.com

[Sushi]

Pleas share it on thingiverse.com

Linksy II

[ripper121]

thx