Talk about (almost) anything
by Ouchitburns » Fri Jul 10, 2015 4:25 am
Hello,
I am currently creating my own Gamebuino clone and I am following the Gamebuino_r3_Schematics.pdf. My question is what are BTN0, BTN1, BTN2, and BTN3? I know they are the directional buttons but are they Up, Right, Down, and Left? Any insight on this would be awesome and would save me solder and headaches. Thanks
OuchitBurns
-
Ouchitburns
-
- Posts: 2
- Joined: Fri Jul 10, 2015 4:12 am
by adekto » Fri Jul 10, 2015 1:22 pm
i dont have the answer but u can try and do them on a breadboard first and see wich is wich
-
adekto
-
- Posts: 448
- Joined: Tue Feb 25, 2014 9:47 pm
- Location: belgium
by Ouchitburns » Fri Jul 10, 2015 4:40 pm
Re: Gamebuino directional button maps
Postby adekto » Fri Jul 10, 2015 1:22 pm
i dont have the answer but u can try and do them on a breadboard first and see wich is wich
Thanks for your response. Normally I would have done just that, but I am still waiting on my display to arrive in the mail. Luckily I went ahead and read the settings.c file and finally found the answer I was looking for.
- Code: Select all
//buttons pins
#define BTN_UP_PIN 9
#define BTN_RIGHT_PIN 7
#define BTN_DOWN_PIN 6
#define BTN_LEFT_PIN 8
#define BTN_A_PIN 4
#define BTN_B_PIN 2
#define BTN_C_PIN A3
Thanks again
Ouchitburns
-
Ouchitburns
-
- Posts: 2
- Joined: Fri Jul 10, 2015 4:12 am
Return to General forum
Who is online
Users browsing this forum: No registered users and 2 guests